Command Reference
R&S
®
ZNB/ZNBT
1010User Manual 1173.9163.02 ─ 55
Parameters:
<Scope> GLOBal | CHANnel
CHANnel – when all the sweeps for each channel are complete
GLOBal – when all sweeps in all channels are complete
Note:*RST or "Preset" do not change the configuration of the
Universal Interface. Use CONTrol:HANDler:RESet to restore
default values.
*RST: n/a (default: GLOBal)
Example: See CONTrol:HANDler:PASSfail:MODE
CONTrol:HANDler:PASSfail:STATus?
Returns the global pass/fail status of the last measurement.
Return values:
<Status> PASS | FAIL | NONE
PASS – all measurements that are not in single sweep mode (on
hold) have been swept, and all limit checks have been passed.
FAIL – all measurements that are not in single sweep mode (on
hold) have been swept, at least one limit check failed according
to the specified pass/fail policy (CONTrol:HANDler:
PASSfail:POLicy).
NONE – no pass/fail status available, e.g. because the measure-
ment is in progress or because no limit check has been defined.
*RST: n/a
Example: Preparations: Configure and enable a limit check. Start a mea-
surement and wait until the sweep is complete.
CONTrol:HANDler:PASSfail:STATus?
Query the result of the global limit check.
Usage: Query only
CONTrol:HANDler:RESet
Restores the default states of the CONTrol:HANDler... commands including the
data port values.
Example:
See CONTrol:HANDler[:EXTension]:INDex:STATe
Usage: Event
CONTrol:HANDler:SWEepend <SweepEnd>
Specifies the event that will cause the /SWEEP END line (pin 34) to go low; see Chap-
ter 11.3.4.4, "Timing of Control Signals", on page 1438.
Parameters:
<SweepEnd> SWEep | CHANnel | GLOBal
SCPI Command Reference
To Next Page
Loading...
