Skew and Side-to-Side Adjustment
SM 1-117 B234/B235/B236/D101/D102/D103
Installation
To Correct Side-to-Side Registration
Important
• This adjustment can be done on the left side of the copier, at the Z-Folding unit
B660, at the cover interposer tray B835, and at the booklet finisher B836.
1. Loosen screws , , , ).
2. Remove the bracket [A] (x1), rotate it 90 degrees, then refasten it.
NOTE: Re-positioning the bracket aligns the oval cut-out horizontally so that
you can slide the joint bracket to slide from side-to-side.
3. Use the scale [B] at the top of the rear end of the bracket.
If the deviation from center was toward the front of the machine, slide the
bracket to the front and fasten it with the screw.
-or-
If the deviation from center was toward the back of the machine, slide the
bracket to the rear and fasten it with the screw.
B234I991.WMF
[A]
[B]
Scale: 2 mm
To Next Page
Loading...
