Main Service Program Mode Tables
SM 5-55 B234/B235/B236/D101/D102/D103
Service
Tables
5182 HDD Page Mgmt
These SP codes are used to change the configuration of the TEMP partition for
raw data on the HDD so the local storage (LS) area can be expanded.
The SP codes below cannot be set together. If one is selected that SP is enabled
and the other reset to its default value. For example, if 002 is set to on (1) while
001 set to on (1), 002 is set to and 001 is automatically reset to its default (0:
Normal).
001 Release LS Limit
Normally LS can handle up to 15,000 pages. Use this SP code to select
expansion of the page storage area.
[0~1/0/1]
0: Normal
1: Allow Expansion
002 Change Pages/Doc
The configuration of the TEMP area on the HDD must be changed in order to
increase the number of pages that 1 document can hold when it is stored on the
HDD. If the size of the LS area is increased, the size of the TEMP area must be
decreased. Changing this SP increases the default value for the size of the LS
area from 5,000 pages to 20,000 pages. A larger setting is not possible.
[0~1/0/1]
0: Normal
1: Allow Expansion
5185 TCRU: Set Machine DFU
NIA
[Asymmetrical] Symmetrical
5187 PM Counter Print Out in UP
This setting determines whether parts without standard counts print in addition to
the normal counter list
[0~1/0/1]
0: No
1: Yes
5212 Page Numbering
003 Duplex Printout Left/Right Position
Horizontally positions the page numbers
printed on both sides during duplexing.
[–10~+10/1 mm]
0 is center, minus is left, + is right.
004 Duplex Printout High/Low Position
Vertically positions the page numbers
printed on both sides during duplexing.
[–10~+10/1 mm]
0 is center, minus is down, + is up.
To Next Page
Loading...
