EasyManuals Logo

ST STM32F405 User Manual

ST STM32F405
1749 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1699 background imageLoading...
Page #1699 background image
RM0090 Rev 18 1699/1749
RM0090 Debug support (DBG)
1713
38.13 DWT (data watchpoint trigger)
The DWT unit consists of four comparators. They are configurable as:
a hardware watchpoint or
a trigger to an ETM or
a PC sampler or
a data address sampler
The DWT also provides some means to give some profiling informations. For this, some
counters are accessible to give the number of:
Clock cycle
Folded instructions
Load store unit (LSU) operations
Sleep cycles
CPI (clock per instructions)
Interrupt overhead
38.14 ITM (instrumentation trace macrocell)
38.14.1 General description
The ITM is an application-driven trace source that supports printf style debugging to trace
Operating System (OS) and application events, and emits diagnostic system information.
The ITM emits trace information as packets which can be generated as:
Software trace. Software can write directly to the ITM stimulus registers to emit
packets.
Hardware trace. The DWT generates these packets, and the ITM emits them.
Time stamping. Timestamps are emitted relative to packets. The ITM contains a 21-bit
counter to generate the timestamp. The Cortex
®
-M4 with FPU clock or the bit clock rate
of the Serial Wire Viewer (SWV) output clocks the counter.
The packets emitted by the ITM are output to the TPIU (Trace Port Interface Unit). The
formatter of the TPIU adds some extra packets (refer to TPIU) and then output the complete
packets sequence to the debugger host.
The bit TRCEN of the Debug Exception and Monitor Control Register must be enabled
before programming or using the ITM.
38.14.2 Time stamp packets, synchronization and overflow packets
Time stamp packets encode time stamp information, generic control and synchronization. It
uses a 21-bit timestamp counter (with possible prescalers) which is reset at each time
stamp packet emission. This counter can be either clocked by the CPU clock or the SWV
clock.
A synchronization packet consists of 6 bytes equal to 0x80_00_00_00_00_00 which is
emitted to the TPIU as 00 00 00 00 00 80 (LSB emitted first).
A synchronization packet is a timestamp packet control. It is emitted at each DWT trigger.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ST STM32F405 and is the answer not in the manual?

ST STM32F405 Specifications

General IconGeneral
BrandST
ModelSTM32F405
CategoryComputer Hardware
LanguageEnglish

Related product manuals