Reset and clock control for STM32F405xx/07xx and STM32F415xx/17xx(RCC) RM0090
264/1749 RM0090 Rev 18
Bits 27:15 Reserved, must be kept at reset value.
Bits 14:6 PLLI2SN: PLLI2S multiplication factor for VCO
These bits are set and cleared by software to control the multiplication factor of the VCO.
These bits can be written only when PLLI2S is disabled. Only half-word and word accesses
are allowed to write these bits.
Caution: The software has to set these bits correctly to ensure that the VCO output
frequency is between 100 and 432 MHz.
VCO output frequency = VCO input frequency × PLLI2SN with 50 ≤ PLLI2SN ≤ 432
000000000: PLLI2SN = 0, wrong configuration
000000001: PLLI2SN = 1, wrong configuration
...
000110010: PLLI2SN = 50
...
001100011: PLLI2SN = 99
001100100: PLLI2SN = 100
001100101: PLLI2SN = 101
001100110: PLLI2SN = 102
...
110110000: PLLI2SN = 432
110110001: PLLI2SN = 433, wrong configuration
...
111111111: PLLI2SN = 511, wrong configuration
Note: Multiplication factors ranging from 50 and 99 are possible for VCO input frequency
higher than 1 MHz. However care must be taken that the minimum VCO output
frequency respects the value specified above.
Bits 5:0 Reserved, must be kept at reset value.
To Next Page
Loading...
Need help?
General
