User's Manual 9. Configuring VoIP Parameters
Version 4.4.0 115 MP26x/MP27x
13. From the ‘Header’ drop-down list, select RAW (header-less).
14. From the ‘Encoding’ drop-down list, select U-law.
15. Click OK.
16. In the ‘Export File’ dialog box, click Save.
9.5.1.2 Configuring Auto Attendant on Device
The following procedures describe how to configure the Auto Attendant feature on the
device.
9.5.1.3 Saving Auto Attendant Recordings on USB
Saving Auto Attendant Recordings on USB can be performed as described below.
To save Auto Attendant recordings on USB:
1. Record an Auto Attendant message as described is Section 9.5.1.1.
2. Copy the file to the main directory in the USB storage device.
3. Insert the USB storage device into a USB port on the device.
Note: Under current implementation, the USB storage device must be plugged
into the device during startup, and each time that the device reboots. The
USB storage device can be extracted after all the three main LEDs (Status,
Broadband, and Phone) are lit green. We recommend leaving the USB
storage device plugged into the device throughout the operation of the
device.
To Next Page
Loading...
Need help?
General
