User's Manual 134 Document #: LTRT-23510
MP-26x/MP-27x Multimedia Home Gateway
10.6 Establishing a 3-Way Conference Call
The procedure below describes how to establish a 3-way conference call. The method for
doing this depends on how you configured the flash-hook functionality, using the ‘Flash
keys sequence style’ parameter in Section 9.2 on page 97. In addition, to configure 3-way
conferencing, see Section 9.5 on page 108.
To establish a 3-way conference call when 'Flash only' is set:
1. During a call with party B, press the flash key button on your phone; Party B is placed
on hold and a dial tone is heard.
2. Dial party C's number and wait until the call is established.
3. Press the flash key button again to add parties B and C to a 3-way conference call.
4. To end the 3-way conference call, on-hook your phone (or alternatively, press the
flash key button again).
To establish a 3-way conference call when 'Flash + digits sequence' is
set:
1. During a call with party B, press the flash key button on your phone and then press the
'1' key; Party B is placed on hold and a dial tone is heard.
2. Dial party C's number and wait until the call is established.
3. Press the flash key button and then press the '3' key to add B and C to a 3-way
conference call.
4. To end the 3-way conference call, on-hook your phone (or alternatively, press the
flash key button and then press the '3' key).
To Next Page
Loading...
