User's Manual 12. Network Connections
Version 4.4.0 183 MP26x/MP27x
12.2.1.3.3 Enabling WPS
The procedure below describes how to enable WPS. WPS is a method for simplifying the
security setup and management of wireless networks. This feature is disabled by default.
By enabling it, you can control the setup of your wireless security, which is defined under
the Security group (see Section 12.2.1.3.4 on page 189).
To enable WPS:
1. From the menu bar, click the Network Connections menu; the 'Network Connections'
screen appears.
Figure 12-48: Network Connections
2. Click the Edit icon corresponding to the 'LAN Wireless 802.11n Access Point -
Virtual AP Properties' page; the LAN Wireless 802.11n Access Point Properties
page
appears.
To Next Page
Loading...
Need help?
General
