User's Manual 124 Document #: LTRT-23510
MP-26x/MP-27x Multimedia Home Gateway
9.10 Bluetooth
The device gateway supports Bluetooth. The sub-sections below describe Bluetooth
functionality.
9.10.1 Pairing Mobile Devices to Device using Bluetooth
Before connecting the device to a mobile device through Bluetooth, note the following:
Notes:
• The mobile device should be in the same room as the device.
• The mobile device should be not more than four meters (line of sight) from
the device.
• The mobile device and the device should be placed
coverage is reasonable for regular mobile calls, without call failures or
voice interference.
The procedure below shows how to pair the device gateway to mobile devices using
Bluetooth.
To pair the mobile device:
1. In the 'Voice Over IP' screen, access the Bluetooth tab; the following screen appears.
Figure 9-24: Bluetooth Screen (e.g., MP-264)
2. Under the Bluetooth group, select the Enabled check box to enable the device.
3. By default the ‘Bluetooth Name’ is “MP264” and the ‘PIN’ is “1234”. You can change
these values if you wish.
To Next Page
Loading...
Need help?
General
