User's Manual 10. Making VoIP Calls with your Analog Telephones
Version 4.4.0 133 MP26x/MP27x
10.5 Forwarding Calls to another Phone
The procedure below describes how to automatically forward incoming (received) calls to
another phone. Before you can forward calls, you need to enable and configure call
forwarding as described in Section 9.5 on page 108.
Note: The Call Forward feature is functional only when the device is registered to a
proxy.
To forward calls to another phone:
1. Pick up the phone and make sure that you can hear a dial tone.
2. Dial the call forward key sequence (according to your configuration), for example, *32;
a dial tone is heard.
3. Dial the number of the phone to where you want calls forwarded; a stutter tone is
heard.
4. Replace the receiver; all incoming calls are forwarded. Every time you pick up the
phone receiver, a stutter tone is played (for the length of time, as you configured for
the 'Stutter Tone Duration' parameter).
To deactivate call forwarding:
1. Pick up the phone; a stutter tone is heard.
2. Dial the call forward key sequence.
3. Replace the receiver.
4. To make sure that call forwarding has been de-activated, pick up the phone again; a
regular dial tone should be heard (not the stutter tone).
To Next Page
Loading...
Need help?
General
