User's Manual 14. Security
Version 4.4.0 265 MP26x/MP27x
6. In the screen 'Edit Service', click the link New Opened Ports; the screen 'Edit Service
Opened Ports' opens.
7. Similar to the trigger ports screen, select UDP as the protocol, leave the source port at
'Any', and enter a 333 as the single destination port.
Figure 14-15: Edit Service Opened Ports
8. Click OK to save the settings; the screen 'Edit Service' presents your entered
information. Click OK again to save the port triggering rule; the screen 'Port Triggering'
now includes the new port triggering entry.
Figure 14-16: New Port Triggering Rule
You can disable a port triggering rule without having to remove it from the screen 'Port
Triggering':
To temporarily disable a rule, clear the check box corresponding to the service name.
To reinstate it later, simply reselect the check box.
To remove a rule, click the Remove icon for the service; the service is
permanently removed.
There may be a few default port triggering rules listed when you first access the port
triggering screen. Note that disabling these rules may result in impaired device
functionality.
To Next Page
Loading...
Need help?
General
