User's Manual 24. Getting Started
Version 4.4.0 393 MP26x/MP27x
24 Getting Started
24.1 Installing the DECT Phone
The procedure below describes how to install the DECT phone on the device unit.
To install the DECT phone:
1. The handset is shipped with rechargeable batteries already installed in the battery
compartment. However, a plastic sheath separates the batteries from the handset’s
electrical circuit. Before you can charge the handset, you need to remove this plastic
sheath. On the handset, pull out the plastic tab jutting out from the battery
compartment. This closes the battery circuit and provides power to the handset.
Figure 24-1: Plastic Tab Jutting out from Battery Compartment
2. On the lower part of the device front panel, remove the cover protecting the connector
for the handset cradle.
3. Attach the handset cradle to the unit by inserting it into the exposed groove and then
pushing it up so that it clicks on to the connector. Attach the removed cover to the
front of the cradle.
Figure 24-2: Attaching Handset Cradle to Base Unit (e.g., MP-264)
4. Place the handset in the cradle and leave to charge for at least 16 hours prior to initial
use.
To Next Page
Loading...
Need help?
General
