User's Manual 276 Document #: LTRT-23510
MP-26x/MP-27x Multimedia Home Gateway
• Accept Packet: Allow access to packets that match the source and destination
IP addresses and service ports defined in 'Matching'. The data transfer session is
not handled using Stateful Packet Inspection (SPI), meaning that other packets
that match this rule are not automatically allowed access. For example, this can
useful when creating rules that allow broadcasting.
7. Under the section 'Logging', select the parameter 'Log Packets Matched By This Rule'
to log the first packet from a connection that was matched by this rule.
8. By default, the 'Schedule' rule is always active. However, you can configure scheduler
rules to define time segments during which the rule may be active.
9. Click OK to save the settings.
To Next Page
Loading...
Need help?
General
