6. EM GUI orientation
How to add Output
Outputs configurations can be added manually to unassigned connectors.
1. Click on the Add Output button.
The A dd Output button is replaced by the Done Adding bu tton (highlighted in blue).
2. In the System diagram area, c lick on the connector(s) that need to be as signed.
Note: If the output is 4K provided by the 4 SDI connectors, the 4 SDI connectors need to be se lected.
Connector(s) is immediately highlighted in blue.
3. The s election is completed by clicking the Done Adding button that is highlighted in blue.
A new Output is added in the output list.
How to delete Output
1. Click on the Delete O utput(s) button
The D elete Outp ut(s) button is replaced by the Delete Selected button (highlighted in red).
2. Click on the corresponding connector in the graphical area.
Or,
click in the “x” on the right hand side in the output configuration list.
Connector(s) is immediately highlighted in blue.
3. The deletion is completed by clicking the Delete Selected button.
Multiple conn ector config urations can be selected to be deleted together.
You can only delete Output C onfigurations that are not assig ned in Destinations.
How to access to the output configuration adjustments
Adjustments to outputs are performed in the “Adjust” panel:
1. Select the output from the configuration list
Or,
clicking on the connector graphic.
An output is selected.
2. Click on the Adjust tab that is on the top of the A djustment area.
R5905948 EVENT MASTER DEVICES 17/07/2017
121
To Next Page
Loading...
