DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
120
5. Layer 2 Features
FDB
VLAN
VLAN Tunnel
STP
ERPS (G.8032)
Loopback Detection
Link Aggregation
Flex Links
L2 Protocol Tunnel
L2 Multicast Control
LLDP
FDB
Static FDB
Unicast Static FDB
This window is used to display and configure the static unicast forwarding settings on the Switch.
To view the following window, click L2 Features > FDB > Static FDB > Unicast Static FDB, as shown below:
Figure 5-1 Unicast Static FDB Window
The fields that can be configured are described below:
Parameter Description
Port/Drop
Allows the selection of the port number on which the MAC address entered
resides. This option could also drop the MAC address from the unicast static FDB.
Select the port number when selecting the Port.
Unit
Select the stacking unit ID of the Switch that will be configured here.
Port Number
After selecting the Port option, select the port number used here.
VID
Enter the VLAN ID on which the associated unicast MAC address resides.
MAC Address
Enter the MAC address to which packets will be statically forwarded. This must be
a unicast MAC address.
Click the Apply button to accept the changes made.
Click the Delete All button to delete all the entries found in the display table.
Click the Delete button to delete the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
To Next Page
Loading...
