D-Link DGS-3630 SERIES - MAC Address Table

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
123
The fields that can be configured are described below:
Parameter Description
VID List
Enter the VLAN ID(s) that will be used in this configuration or display here. A
series of VLAN IDs can be entered separated by commas or a range of VLAN IDs
can be entered separated by a hyphen.
Status
Select to enable or disable the MAC address learning function on the VLAN(s)
specified here.
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Show All button to display all the available entries.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
MAC Address Table
This window is used to view the entries listed in the MAC address table.
To view the following window, click L2 Features > FDB > MAC Address Table, as shown below:
Figure 5-6 MAC Address Table Window
The fields that can be configured are described below:
Parameter Description
Port
Select the stacking unit ID and the port number of the Switch that will be
configured here.
VID
Enter the VLAN ID that will be used for this configuration here.
MAC Address
Enter the MAC address that will be used for this configuration here.
Click the Clear Dynamic by Port button to clear the dynamic MAC address listed on the corresponding port.
Click the Clear Dynamic by VLAN button to clear the dynamic MAC address listed on the corresponding VLAN.
Click the Clear Dynamic by MAC button to clear the dynamic MAC address entered.