DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
563
Parameter Description
Mask
Enter the FEC subnet mask of the FTN here.
Click the Find button to locate a specific entry based on the information entered.
MPLS LDP Neighbor Password Settings
This window is used to display and configure the MPLS LDP neighbor password settings. If the MD5 authentication is
enabled, the LSR only establishes sessions with the peer when they exchange the same password. The password
setting will be applied to negotiation with link neighbors or targeted neighbors.
To view the following window, click MPLS > MPLS LDP Neighbor Password Settings, as shown below:
Figure 11-4 MPLS LDP Neighbor Password Settings Window
The fields that can be configured are described below:
Parameter Description
Neighbor IP
Enter the neighbor IPv4 address here. This address will also be the neighbor’s
(peer) LSR ID.
Password
Enter the LDP peer password here. Select the Default option to use the default
password (which is empty).
Click the Apply button to accept the changes made.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
MPLS LDP Neighbor Targeted Settings
This window is used to display and configure the MPLS LDP neighbor targeted settings. LDP sends the targeted hello
message at the configured interval to discover the neighbor. For a discovered neighbor, LDP maintains a hold-timer.
The neighbor will time out if the timer has expired without the receipt of a hello message from the neighbor.
To view the following window, click MPLS > MPLS LDP Neighbor Targeted Settings, as shown below:
To Next Page
Loading...
