DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
612
Configuration Restore & Backup
Configuration Restore from HTTP
This window is used to initiate a configuration restore from a local PC using HTTP.
To view the following window, click Tools > Configuration Restore & Backup > Configuration Restore from HTTP,
as shown below:
Figure 15-10 Configuration Restore from HTTP Window
The fields that can be configured are described below:
Parameter Description
Unit
Select the Switch unit that will be used for this configuration here.
Source File
In this field the source configuration file’s filename and path will be displayed after
selection. To navigate to the location of the configuration file located on the local
PC, either double click in the text box or click the Browse button.
Destination File
Enter the destination path and location where the configuration file should be
stored on the Switch. This field can be up to 64 characters long. Select the
running-config option to restore and overwrite the running configuration file on
the Switch. Select the startup-config option to restore and overwrite the start-up
configuration file on the Switch.
Replace
Select this option to replace the configuration file on the Switch with this one.
Click the Restore button to initiate the configuration restore.
Configuration Restore from TFTP
This window is used to initiate a configuration restore from a TFTP server.
To view the following window, click Tools > Configuration Restore & Backup > Configuration Restore from TFTP,
as shown below:
Figure 15-11 Configuration Restore from TFTP Window
The fields that can be configured are described below:
To Next Page
Loading...
