D-Link DGS-3630 SERIES - 11 Mpls; MPLS LDP Information Settings

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
558
11. MPLS
MPLS LDP Information Settings
MPLS LSP Trigger Information
MPLS Forwarding Settings
MPLS LDP Neighbor Password Settings
MPLS LDP Neighbor Targeted Settings
MPLS LDP Neighbor Information
MPLS Global Settings
MPLS LDP Interface Settings
MPLS LDP Session Information
MPLS LDP Statistic
MPLS LDP Binding Table
MPLS LDP Discovery Information
MPLS QoS Settings
Ping MPLS
Traceroute MPLS IPv4
MPLS LDP Information Settings
This window is used to display and configure the Multiprotocol Label Switching (MPLS) Label Distribution Protocol
(LDP) information settings.
To view the following window, click MPLS > MPLS LDP Information Settings, as shown below:
Figure 11-1 MPLS LDP Information Settings Window
The fields that can be configured are described below:
Parameter Description
LSR ID
Enter the Label Switching Router (LSR) ID here. The IPv4 address must be an
IPv4 address of an existing interface. The LSR ID is used to identify the LSR in
the MPLS network. Select the Default option to use the default setting.
LDP Version
In this field the LDP version will be displayed.
LDP State
Select to enable or disable the LDP feature here.
TCP Port
In this field the LDP TCP port number will be displayed.
UDP Port
In this field the LDP UDP port number will be displayed.