D-Link DGS-3630 SERIES - System Log; System Log Settings

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
15
Click the Apply button to accept the changes made.
System Log
System Log Settings
This window is used to display and configure the system log settings.
To view the following window, click System > System Log > System Log Settings, as shown below:
Figure 3-11 System Log Settings Window
The fields that can be configured for Log State are described below:
Parameter Description
Log State
Select the enable or disable the global system log state here.
Click the Apply button to accept the changes made.
The fields that can be configured for Source Interface Settings are described below:
Parameter Description
Source Interface State
Select this option to enable or disable the global source interface state.
Type
Select the type of interface that will be used. Options to choose from are
Loopback, Mgmt, and VLAN.
VID
Enter the interface VID used here. For loopback interfaces this ID can be from 1
to 8. For the management (Mgmt) interface this value is always 0. For VLAN