DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
127
Figure 5-11 Protocol VLAN Profile Interface Window
The fields that can be configured are described below:
Parameter Description
Port
Select the stacking unit ID and the port number of the Switch that will be
configured here.
Profile ID
Select the 802.1v protocol VLAN profile ID here.
VID
Enter the VLAN ID used here.
Priority
Select the priority value used here. This value is between 0 and 7. This parameter
is specified to re-write the 802.1p default priority previously set in the Switch,
which is used to determine the CoS queue that packets are forwarded to. Once
this field is specified, packets accepted by the Switch that match this priority are
forwarded to the CoS queue specified previously.
Click the Apply button to accept the changes made.
Click the Delete button to remove the specific entry.
GVRP
GVRP Global
This window is used to display and configure the global GARP VLAN Registration Protocol (GVRP) settings.
To view the following window, click L2 Features > VLAN > GVRP > GVRP Global, as shown below:
Figure 5-12 GVRP Global Window
The fields that can be configured are described below:
Parameter Description
Global GVRP State
Select to enable or disable the global GVRP state here.
Dynamic VLAN Creation
Select to enable or disable the dynamic VLAN creation function here.
NNI BPDU Address
Select the NNI BPDU address option here. This option is used to determine the
BPDU protocol address for GVRP in customer networks. It can use 802.1d GVRP
address or 802.1ad service provider GVRP address. Options to choose from are
Dot1d and Dot1ad.
Click the Apply button to accept the changes made.
To Next Page
Loading...
