DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
124
Click the Find button to locate a specific entry based on the information entered.
Click the Clear All button to clear all dynamic MAC addresses.
Click the Show All button to display all the MAC addresses recorded in the MAC address table.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
MAC Notification
This window is used to display and configure MAC notification.
To view the following window, click L2 Features > FDB > MAC Notification, as shown below:
Figure 5-7 MAC Notification (MAC Notification Settings) Window
The fields that can be configured are described below:
Parameter Description
MAC Address Notification
Select to enable or disable MAC notification globally on the Switch
Interval
Enter the time value between notifications. This value must be between 1 and
2147483647 seconds. By default, this value is 1 second.
History Size
Enter the maximum number of entries listed in the history log used for notification.
This value must be between 0 and 500. By default, this value is 1.
MAC Notification Trap State
Select to enable or disable the MAC notification trap state.
Trap Type
Select the trap type here. Options to choose from are:
• Without VID - Specifies the trap information without the VLAN ID.
• With VID - Specifies the trap information with the VLAN ID.
Unit
Select the stacking unit ID of the Switch that will be configured here.
From Port - To Port
Select the range of ports that will be used for this configuration here.
Added Trap
Select to enable or disable the added trap for the port(s) selected.
Removed Trap
Select to enable or disable the removed trap for the port(s) selected.
To Next Page
Loading...
