D-Link DGS-3630 SERIES - Route Preference

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
232
Figure 6-26 IPv6 Route Table Window
The fields that can be configured are described below:
Parameter Description
IPv6 Address
Select and enter the IPv6 address to display here.
IPv6 Address/Prefix Length
Select and enter the IPv6 address and prefix length to display here. Select the
Longer Prefixes option to display the route and all of the more specific routes.
Interface Name
Select and enter the name of the interface to display here.
Connected
Select this option to display only connected routes.
RIPng
Select this option to display only RIPng routes.
OSPFv3
Select this option to display only OSPFv3 routes.
ISIS
Select this option to display only ISIS routes.
BGP
Select this option to display only BGP routes.
Database
Select this option to display all the related entries in the routing database instead
of just the best route.
Hardware
Select this option to display only hardware routes. Hardware routes are routes
that have been written into the hardware chip.
Summary
Select this option to display a summary and count of the route sources configured
on this Switch.
Click the Find button to locate a specific entry based on the information entered.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
Route Preference
This window is used to display and configure the route preference settings. Use this window to configure the distance,
which represents the route's trust rating. The route with a lower distance value is preferred over the route with a higher
distance value. A route with the distance 255 will not be installed for routing of packets since it indicates that the route
is not trusted.
To view the following window, click L3 Features > Route Preference, as shown below:
Figure 6-27 Route Preference Window
The fields that can be configured are described below: