D-Link DGS-3630 SERIES - Dhcpv6 Server Interface Settings

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
64
To view the following window, click Management > DHCP > DHCPv6 Server > DHCPv6 Server Exclude Address,
as shown below:
Figure 4-42 DHCPv6 Server Exclude Address Window
The fields that can be configured are described below:
Parameter Description
Low IPv6 Address
Enter the excluded IPv6 address or first IPv6 address in the excluded address
range here.
High IPv6 Address
Enter the last IPv6 address in the excluded address range here (optional).
Click the Apply button to accept the changes made.
Click the Delete button to remove the specified entry.
DHCPv6 Server Binding
This window is used to view and clear the DHCPv6 server binding entries.
To view the following window, click Management > DHCP > DHCPv6 Server > DHCPv6 Server Binding, as shown
below:
Figure 4-43 DHCPv6 Server Binding Window
The fields that can be configured are described below:
Parameter Description
IPv6 Address
Enter the binding entry IPv6 address to be displayed or cleared here. Select the
All option to display or clear all DHCPv6 client prefix bindings in or from the
binding table.
Click the Find button to locate a specific entry based on the information entered.
Click the Clear button to clear the entries based on the information specified.
DHCPv6 Server Interface Settings
This window is used to display and configure the DHCPv6 server interface settings.