DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
682
Appendix E - IETF RADIUS Attributes Support
Remote Authentication Dial-In User Service (RADIUS) attributes carry specific authentication, authorization,
information and configuration details for the request and reply. This appendix lists the RADIUS attributes currently
supported by the Switch.
RADIUS attributes are supported by the IETF standard and Vendor-Specific Attribute (VSA). VSA allows the vendor to
create an additionally owned RADIUS attribute. For more information about D-Link VSA, refer to the RADIUS
Attributes Assignment Appendix.
IETF standard RADIUS attributes are defined in the RFC 2865 Remote Authentication Dial-In User Service (RADIUS),
RFC 2866 RADIUS Accounting, RFC 2868 RADIUS Attributes for Tunnel Protocol Support, and RFC 2869 RADIUS
Extensions.
The following table lists the IETF RADIUS attributes supported by the D-Link Switch.
RADIUS Authentication Attributes:
Number IETF Attribute
1 User-Name
2 User-Password
3 CHAP-Password
4 NAS-IP-Address
5 NAS-Port
6 Service-Type
7 Framed-Protocol
8 Framed-IP-Address
12 Framed-MTU
18 Reply-Message
24 State
26 Vendor-Specific
27 Session-Timeout
29 Termination-Action
30 Called-Station-ID
31 Calling-Station-ID
32 NAS-Identifier
60 CHAP-Challenge
61 NAS-Port-Type
64 Tunnel-Type
65 Tunnel-Medium-Type
77 Connect-Info
79 EAP-Message
80 Message-Authenticator
81 Tunnel-Private-Group-ID
85 Acct-Interim-Interval
87 NAS-Port-ID
95 NAS-IPv6-Address
To Next Page
Loading...
