DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
214
6. Layer 3 Features
ARP
Gratuitous ARP
IPv6 Neighbor
Interface
UDP Helper
IPv4 Static/Default Route
IPv4 Static Route BFD
IPv4 Route Table
IPv6 Static/Default Route
IPv6 Static Route BFD
IPv6 Route Table
Route Preference
ECMP Settings
IPv6 General Prefix
IP Tunnel Settings
URPF Settings
VRF
RIP
RIPng
OSPF
IP Multicast Routing Protocol
BGP
BFD
ISIS
IP Route Filter
Policy Route
VRRP Settings
VRRPv3 Settings
ARP
ARP Elevation
This window is used to display and configure the Address Resolution Protocol (ARP) elevation state. This is used to
allow all ARP traffic to the Switch where the destination is the Switch itself. This traffic will take a higher priority than
other ARP packets.
To view the following window, click L3 Features > ARP > ARP Elevation, as shown below:
Figure 6-1 ARP Elevation Window
The fields that can be configured are described below:
Parameter Description
ARP Elevation State
Select to enable or disable the ARP elevation feature here.
Click the Apply button to accept the changes made.
To Next Page
Loading...
