DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
580
Parameter Description
Description
Enter the L2VC interface description here. This name can be up to 64 characters
long.
Click the Apply button to accept the changes made.
The fields that can be configured for Find L2VC Interface Description are described below:
Parameter Description
L2VC Interface Name
Enter the L2VC interface name here. This name can be up to 64 characters long.
Click the Find button to locate a specific entry based on the information entered.
Click the Show All button to display all the available entries.
Click the Delete Description button to delete the description for the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
VPLS Settings
This window is used to display and configure the Virtual Private LAN Service (VPLS) settings.
To view the following window, click MPLS L2VPN > VPLS Settings, as shown below:
Figure 12-5 VPLS Settings Window
The fields that can be configured for VPLS Settings are described below:
Parameter Description
VPLS Name
Enter the VPLS instance name here. This name can be up to 32 characters long.
VPLS Type
Select the VPLS type here. Options to choose from are:
• Manual - Specifies to manually configure neighbors and use LDP for
signaling.
• Autodiscovery - Specifies to use BGP for auto-discovery and signaling.
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Show All button to display all the available entries.
The fields that can be configured for VPLS AC Settings are described below:
To Next Page
Loading...
