DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
601
Figure 13-22 Device Environment Window
External Alarm Settings
This window is used to display and configure the external alarm settings. This is used to enable monitoring the
external alarm source status or to configure external alarm message for a channel. The source of alarm is located
outside of the Switch and is monitored via pre-defined connecting channels. Each channel represents a specific alarm
event. The status of an alarm source can be either in the alarm state or in the normal state. If the source is absent or
the source is present and in the normal state, the status will be normal. The status will be abnormal if the source is in
the abnormal state. A notification will be sent when the monitoring status is changed.
To view the following window, click Monitoring > External Alarm Settings, as shown below:
Figure 13-23 External Alarm Settings Window
The fields that can be configured in External Alarm Trap Settings are described below:
Parameter Description
External Alarm Trap State
Select to enable or disable the external alarm trap state here.
Click the Apply button to accept the changes made.
The fields that can be configured in External Alarm Settings are described below:
Parameter Description
Unit
Select the Switch unit that will be used for this configuration here.
Channel
Select the channel to be configured here. The range is from 1 to 2.
To Next Page
Loading...
