DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
8
Figure 3-3 Peripheral Settings Window
The fields that can be configured in Environment Trap Settings are described below:
Parameter Description
Fan Trap
Select to enable or disable the fan trap state for waning fan event (fan failed or
fan recover).
Power Trap
Select to enable or disable the power trap state for waning power event (power
failed or power recover).
Temperature Trap
Select to enable or disable the temperature trap state for warning temperature
event (temperature thresholds exceeded or temperature recover).
Click the Apply button to accept the changes made.
The fields that can be configured in Environment Temperature Threshold Settings are described below:
Parameter Description
Unit
Select the Switch unit that will be used for this configuration here.
Thermal
Select the thermal sensor ID.
High Threshold
Enter the high threshold value of the warning temperature setting. The range is
from -100 to 200 degrees Celsius. Tick the Default check box to return to the
default value.
Low Threshold
Enter the low threshold value of the warning temperature setting. The range is
from -100 to 200 degrees Celsius. Tick the Default check box to return to the
default value.
Click the Apply button to accept the changes made.
Port Configuration
Port Settings
This window is used to display and configure the Switch’s port settings.
NOTE: The 10M and 100M speed options are only applicable when connecting to the Management
Port (Mgmt 0).
To view the following window, click System > Port Configuration > Port Settings, as shown below:
To Next Page
Loading...
