D-Link DGS-3630 SERIES - Dynamic Arp Inspection

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
484
Parameter Description
URL
Select the location from the drop-down list and enter the URL where the DHCP
snooping database will be loaded from here. Locations to choose from are TFTP,
FTP, and Flash. An example URL is given.
Click the Apply button to accept the changes made.
Click the Clear button to clear all the counter information.
DHCP Snooping Binding Entry
This window is used to display and configure the DHCP snooping binding entries.
To view the following window, click Security > IMPB > IPv4 > DHCPv4 Snooping > DHCP Snooping Binding Entry,
as shown below:
Figure 9-43 DHCP Snooping Binding Entry Window
The fields that can be configured are described below:
Parameter Description
MAC Address
Enter the MAC address of the DHCP snooping binding entry here.
VID
Enter the VLAN ID of the DHCP snooping binding entry here. This value must be
between 1 and 4094.
IP Address
Enter the IP address of the DHCP snooping binding entry here.
Unit
Select the Switch unit that will be used for this configuration here.
Port
Select the appropriate port used for the configuration here.
Expiry
Enter the expiry time value used here. This value must be between 60 and
4294967295 seconds.
Click the Add button to add a new entry based on the information entered.
Click the Delete button to remove the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
Dynamic ARP Inspection
ARP Access List
This window is used to display and configure the dynamic ARP inspection settings.