DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
485
To view the following window, click Security > IMPB > IPv4 > Dynamic ARP Inspection > ARP Access List, as
shown below:
Figure 9-44 ARP Access List Window
The fields that can be configured are described below:
Parameter Description
ARP Access List Name
Enter the ARP access list name used here. This name can be up to 32 characters
long.
Click the Add button to add a new entry based on the information entered.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specified entry.
After clicking the Edit button, the following window will appear.
Figure 9-45 ARP Access List (Edit) Window
The fields that can be configured are described below:
Parameter Description
Action
Select the action that will be taken here. Options to choose from are Permit and
Deny.
IP
Select the type of sender IP address that will be used here. Options to choose
from are Any, Host, and IP with Mask.
Sender IP
After selecting the Host or IP with Mask options as the type of IP, enter the
sender IP address used here.
Sender IP Mask
After selecting the IP with Mask option as the type of IP, enter the sender IP
mask used here.
MAC
Select the type of sender MAC address that will be used here. Options to choose
from are Any, Host, and MAC with Mask.
Sender MAC
After selecting the Host or MAC with Mask options as the type of MAC, enter the
sender MAC address used here.
Sender MAC Mask
After selecting the MAC with Mask option as the type of MAC, enter the sender
MAC mask used here.
To Next Page
Loading...
