DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
356
Parameter Description
Neighbor Address
Select and enter the IPv4 or IPv6 address of the neighboring router here.
Type
Select the type of information to display here. Options to choose from are:
• None - Specifies to display BGP and TCP connection information for
neighbor sessions.
• Advertised Routes - Specifies to display the routes advertised to a BGP
neighbor.
• Received Routes - Specifies to display the routes received from a BGP
neighbor.
• Routes - Specifies to display the routes that are received and accepted from
a neighbor. The accepted routes are a subset of the received routes.
• Received Prefix Filter - Specifies to display the prefix list sent by the
specified neighbor.
Click the Find button to locate a specific entry based on the information entered.
Click the Delete button to remove the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Please Select button, the following page will appear.
Figure 6-197 Neighbor (Please Select) Window
Select the VRF entry and click the OK button to use the selected VRF entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
Peer Group
This window is used to display and configure the BGP neighbor peer group settings.
To view the following window, click L3 Features > BGP > BGP Neighbor > Peer Group, as shown below:
To Next Page
Loading...
