D-Link DGS-3630 SERIES - DNS Name Server Settings

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
85
Parameter Description
IP DNS Lookup Static State
Select to enable or disable the IP DNS lookup static state here.
IP DNS Lookup Cache State
Select to enable or disable the IP DNS lookup cache state here.
IP Domain Lookup
Select to enable or disable the IP domain lookup state here.
IP Name Server Timeout
Enter the maximum time to wait for a response from a specified name server. This
value is between 1 and 60 seconds.
IP DNS Server
Select to globally enable or disable the DNS server feature here.
Click the Apply button to accept the changes made.
The fields that can be configured in IP Domain Lookup Source Interface are described below:
Parameter Description
Source Interface State
Select to enable or disable the source interface state here.
Interface Type
Select the source interface type here. Options to choose from are Loopback,
Mgmt, and VLAN.
VID
Enter the VLAN ID of the source interface here.
Click the Apply button to accept the changes made.
DNS Name Server Settings
This window is used to display and configure the IP address of a domain name server.
To view the following window, click Management > DNS > DNS Name Server Settings, as shown below:
Figure 4-67 DNS Name Server Settings Window
The fields that can be configured are described below:
Parameter Description
VRF Name
Enter the name of the VRF instance here. This name can be up to 12 characters
long.
Name Server IPv4
Select and enter the IPv4 address of the DNS server.
Name Server IPv6
Select and enter the IPv6 address of the DNS server.
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Delete button to remove the specified entry.