D-Link DGS-3630 SERIES - Safeguard Engine Settings

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
514
Protocol Name Sub-interface
(Group)
Description
802.1X
Protocol Port-based Network Access Control
ARP
Protocol Address resolution Protocol
BGP
Protocol Border Gateway Protocol
DHCP
Protocol Dynamic Host Configuration Protocol
DNS
Protocol Domain Name System
DVMRP
Protocol Distance Vector Multicast Routing Protocol
GVRP
Protocol GARP VLAN Registration Protocol
ICMPv4
Protocol Internet Control Message Protocol
ICMPv6-
Neighbor
Protocol IPv6 Internet Control Message Protocol Neighbor Discovery Protocol
(NS/NA/RS/RA)
ICMPv6-Other
Protocol IPv6 Internet Control Message Protocol except Neighbor Discovery
Protocol (NS/NA/RS/RA)
IGMP
Protocol Internet Group Management Protocol
LACP
Protocol Link Aggregation Control Protocol
NTP
Protocol Network Time Protocol
OSPF
Protocol Open Shortest Path First
PIM
Protocol Protocol Independent Multicast
PPPoE
Protocol Point-to-point protocol over Ethernet
RIP
Protocol Routing Information Protocol
SNMP
Manage Simple Network Management Protocol
SSH
Manage Secure Shell
STP
Protocol Spanning Tree Protocol
Telnet
Manage Telnet
TFTP
Manage Trivial File Transfer Protocol
VRRP
Protocol Virtual Router Redundancy Protocol
Web
Manage Hypertext Transfer Protocol (HTTP) and Hypertext Transfer Protocol
Secure (HTTPS)
A customized rate limit (in packets per second) can be assigned to the Safeguard Engine’s sub-interfaces as a whole
or to individual protocols specified by the user in the management interface. Be careful when customizing the rate limit
for individual protocols, using this function, as improper rate limits can cause the Switch to process packets
abnormally.
NOTE: When Safeguard Engine is enabled, the Switch will allot bandwidth to various traffic flows (ARP,
IP) using the FFP (Fast Filter Processor) metering table to control the CPU utilization and limit
traffic. This may limit the speed of routing traffic over the network.
Safeguard Engine Settings
This window is used to display and configure the safeguard engine settings.
To view the following window, click Security > Safeguard Engine > Safeguard Engine Settings, as shown below: