DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
234
Parameter Description
CRC 32 Upper
Select this option to use the upper bits of CRC-32 as the ECMP hashing
algorithm.
TCP/UDP Port
Select this option to use TCP/UDP port number as ECMP hash key.
Click the Apply button to accept the changes made.
The fields that can be configured in ECMP Advance Control Mode are described below:
Parameter Description
ECMP Advance Control
Mode Setting
Select the ECMP advance control mode settings here. This specifies the number
of ECMP or multipath routes and the number of next-hops of each ECMP or
multipath route that will be changed according to the specified value. Options to
choose from are 64, 128, 256, 512, and 1024.
Click the Apply button to accept the changes made.
IPv6 General Prefix
This window is used to display and configure the VLAN interface IPv6 general prefix settings.
To view the following window, click L3 Features > IPv6 General Prefix, as shown below:
Figure 6-30 IPv6 General Prefix Window
The fields that can be configured are described below:
Parameter Description
Interface VLAN
Enter the VLAN interface ID used here. The range is from 1 to 4094.
Prefix Name
Enter the IPv6 general prefix entry name here. This name can be up to 12
characters long.
IPv6 Address
Enter the IPv6 address and prefix length here. The prefix length of the IPv6
address is also the local subnet on the VLAN interface.
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Delete button to delete the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
To Next Page
Loading...
