DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
576
12. MPLS L2VPN
VPWS Settings
L2VC Interface Description
VPLS Settings
VPLS MAC Address Table
VPWS Settings
This window is used to display and configure the Virtual Private Wire Service (VPWS) settings.
To view the following window, click MPLS L2VPN > VPWS Settings, as shown below:
Figure 12-1 VPWS Settings Window
The fields that can be configured for VPWS Settings are described below:
Parameter Description
Unit
Select the Switch unit ID that will be used here.
Port
Select the port that will be used here.
SVID
Select and enter the encapsulated VLAN ID here. The range is from 1 to 4094.
Peer
Enter the peer LSR ID here that is used to identify the other end Provider Edge
(PE).
VC ID
Enter the Pseudo-Wire (PW) service instance ID here. It is used to uniquely
identify the VPWS and it must be unique at both PEs. The range is from 1 to
4294967295.
Type
Select the type here. Options to choose from are None, Manual, Raw, Tagged,
Manual Raw, and Manual Tagged. For the raw mode, S-tags will not be sent
over the PW. For the tagged mode, S-tags will be sent over the PW. By default,
the PW type is in the Ethernet-tag mode.
MTU
Enter the local CE-PE link’s MTU value here that will be advertised to the remote
peer. If the MTU is configured as 0, the LDP will not advertise the local MTU. The
MTU must be same at both the local and remote devices. The range is from 0 to
65535 bytes. By default, this value is 1500 bytes.
Click the Apply button to accept the changes made.
The fields that can be configured for Find VPWS are described below:
To Next Page
Loading...
