DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
562
Figure 11-3 MPLS Forwarding Settings Window
The fields that can be configured for Static FTN Settings are described below:
Parameter Description
FEC
Enter the FEC IPv4 address of the static FTN here.
Mask
Enter the FEC subnet mask of the static FTN here.
Out Label
Enter the out label value for this FEC here. The range is from 0 to 999.
Next Hop
Enter the next hop IPv4 address of this FEC here.
Click the Apply button to accept the changes made.
Click the Delete by IP button to delete the specified entry based on the IP address entered.
Click the Delete All button to delete all the entries.
The fields that can be configured for Static ILM Settings are described below:
Parameter Description
In Label
Enter the incoming label value of the ILM here. The range is from 0 to 999.
Forward Action
Select the forward action that will be taken here. Options to choose from are
Swap Label and Pop.
Swap Label
After selecting to use the Swap Label forward action, enter the swap label value
here. The range is from 0 to 999.
Next Hop
After selecting to use the Swap Label forward action, enter the next hop IPv4
address of the FEC here.
FEC
Enter the FEC IPv4 address that will be associated with the ILM here.
Mask
Enter the FEC subnet mask that will be associated with the ILM here.
Click the Apply button to accept the changes made.
Click the Delete by In Label button to delete the specified entry based on the In Label entered.
Click the Delete All button to delete all the entries.
The fields that can be configured for Find FTN are described below:
Parameter Description
IP Address
Enter the FEC IPv4 address of the FTN here.
To Next Page
Loading...
