DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
180
Parameter Description
Rate Limit
Enter the rate limit value here. The range is from 1 to 1000. Tick the No Limit
option to apply no rate limit on this profile.
Ignore Topology Change
Select to enable or disable the Ignore Topology Change feature here.
Click the Apply button to accept the changes made.
IGMP Snooping AAA Settings
This window is used to display and configure the IGMP snooping AAA settings.
To view the following window, click L2 Features > L2 Multicast Control > IGMP Snooping > IGMP Snooping AAA
Settings, as shown below:
Figure 5-72 IGMP Snooping AAA Settings Window
The fields that can be configured in IGMP Snooping AAA Settings are described below:
Parameter Description
Unit
Select the Switch unit that will be used for this configuration here.
From Port - To Port
Select the range of ports that will be used for this configuration here.
Authentication
Select to enable or disable authentication here. This is used to enable or disable
the authentication function for IGMP join messages. When enabled and the client
wants to join a group, the system will perform authentication first.
Accounting
Select to enable or disable accounting here. This is used to enable or disable
accounting when a listener joining an IGMP group. When enabled and the client
joins a group, the accounting message will be sent to RADIUS.
Click the Apply button to accept the changes made.
The fields that can be configured in IGMP Snooping AAA Table are described below:
Parameter Description
Unit
Select the Switch unit that will be used for this display here.
From Port - To Port
Select the range of ports that will be used for this display here.
Click the Find button to generate the display based on the selections made.
Click the Show All button to display all the available entries.
IGMP Snooping Groups Settings
This window is used to display and configure the IGMP snooping static group, and view IGMP snooping group.
To Next Page
Loading...
