DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
182
IGMP Snooping Filter Settings
This window is used to display and configure the IGMP snooping filter settings.
To view the following window, click L2 Features > L2 Multicast Control > IGMP Snooping > IGMP Snooping Filter
Settings, as shown below:
Figure 5-74 IGMP Snooping Filter Settings Window
The fields that can be configured in IGMP Snooping Rate Limit Settings are described below:
Parameter Description
Unit
Select the Switch unit ID that will be used here.
From Port - To Port
Select the Switch port range that will be used here. This is only available if the
Port option was selected as the action below.
Limit Number
Enter the limit number here. This is to configure the rate of IGMP control packets
that the Switch can process on a specific interface. The range is from 1 to 1000
packets per second. Select the No Limit option to remove the limitation.
Action
Select the action that will be taken here. Options to choose from are Port and
VLAN.
VID
Enter the VLAN ID here. This is the Layer 2 VLAN on a trunk port and applies the
filter to packets that arrive on that VLAN. The range is from 1 to 4094. This is only
available if the VLAN option was selected as the action.
Click the Apply button to accept the changes made.
The fields that can be configured in IGMP Snooping Limit Settings are described below:
To Next Page
Loading...
