D-Link DGS-3630 SERIES - Page 262

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
250
Select the VRF entry and click the OK button to use the selected VRF entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Edit button, the following page will appear.
Figure 6-50 OSPFv2 Process Settings (Edit) Window
The fields that can be configured are described below:
Parameter Description
OSPF State
Select to enable or disable the OSPFv2 state on the specified VRF instance.
Router ID
Enter the router ID in the IPv4 address format here. The router ID is a 32-bit
number assigned to each router running the OSPF protocol. This number
uniquely identifies the router within an AS. Each router has a unique router ID. If
the router is already active when this command is configured, the new router ID
will not take effect immediately. It is applied on the next reload or manual restart
of the OSPF process.
Default Metric
Enter the default metric value used here. The range is from 1 to 16777214.
Type
Select the distance setting type here. Options to choose from are Intra-Area,
Inter-Area, External-1, and External-2.
• Inter-Area - Specifies the distance for OSPF inter-area routes.
• Intra-Area - Specifies the distance for OSPF intra-area routes.
• External-1 - Specifies the distance for OSPF external type-5 and type-7
routes with a type-1 metric.
• External-2 - Specifies the distance for OSPF external type-5 and type-7
routes with a type-2 metric.
Distance
Enter the administrative distance value here. The range is from 1 to 255.
State
Select to enable or disable the Default Originate Information state here. This
feature is used to generate a default external route (type-5 LA) network 0.0.0.0 to
the AS.
Originate
Select the Originate option here. Options to choose from are Always and None.
Selecting the Always option specifies to always generate the default route
regardless of existence of a default route in the redistributed routes.
Metric
Enter the cost value associated with the generated default route here. If not
specified, the default metric cost is 1. The range is from 1 to 65535.
ECMP
Enter the ECMP value for this process here. The range is from 1 to 32.
Click the Apply button to accept the changes made.
After clicking the Show Detail button, the following page will appear.