DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
261
Figure 6-65 OSPFv2 Redistribute Settings Window
The fields that can be configured are described below:
Parameter Description
VRF Name
Enter the name of the VRF instance here. This name can be up to 12 characters
long. Click the Select VRF button to select a pre-configured VRF instance that will
be used here.
Protocol
Select the source protocol that will be redistributed here. Options to choose from
are Connected, Static, RIP, BGP, and ISIS. For routing protocols like Open
Shortest Path First (OSPF), these routes will be redistributed as external to the
autonomous system.
Metric Type
Select the metric type here. Options to choose from are External Type-1 and
External Type-2. This specifies the external link type of the route being
redistributed into the OSPF routing domain. If a metric type is not specified, the
Switch will adopt a Type-2 external route.
Metric
Enter the metric value for the redistributed routes here. The range is from 1 to
16777214.
Router Map Name
Enter the route map name here that filters the imported routes from this source
routing protocol. If not specified, all routes are redistributed.
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Delete button to delete the specified entry.
After clicking the Select VRF button, the following page will appear.
Figure 6-66 OSPFv2 Interface Settings (Select VRF) Window
Select the VRF entry and click the OK button to use the selected VRF entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
To Next Page
Loading...
