DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
270
To view the following window, click L3 Features > OSPF > OSPFv3 > OSPFv3 Passive Interface Settings, as
shown below:
Figure 6-81 OSPFv3 Passive Interface Settings Window
The fields that can be configured are described below:
Parameter Description
Process ID
Enter the OSPFv3 process ID here. The range is from 1 to 65535.
Interface Name
Enter the passive interface name here. This name can be up to 12 characters
long. Select the Default option specify all the interfaces as passive interfaces.
Click the Apply button to accept the changes made.
Click the Delete button to delete the specified entry.
Click the Find button to locate a specific entry based on the information entered.
OSPFv3 Area Settings
This window is used to display and configure the OSPFv3 area settings.
To view the following window, click L3 Features > OSPF > OSPFv3 > OSPFv3 Area Settings, as shown below:
Figure 6-82 OSPFv3 Area Settings Window
The fields that can be configured in OSPFv3 Area Settings are described below:
Parameter Description
Process ID
Enter the process ID of the OSPF area used here. The range is from 1 to 65535.
OSPF Area ID
Enter the OSPF area ID used here. It can be specified as an IPv4 address.
Range
Select this option to consolidate and summarize routes at an area boundary. This
To Next Page
Loading...
