D-Link DGS-3630 SERIES - Page 288

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
276
Figure 6-88 OSPFv3 Virtual Link Settings Window
The fields that can be configured in OSPFv3 Virtual Link are described below:
Parameter Description
Process ID
Enter the ID for an IPv6 OSPF routing process here. It is locally assigned and
should be unique for each IPv6 OSPF routing process on the router. The range is
from 1 to 65535.
Instance ID
Select and enter the instance ID here. The range is from 0 to 255.
Area ID
Enter the OSPF area ID here. It can be specified as an IPv4 address.
Router ID
Enter the router ID here associated with the virtual link neighbor.
Hello Interval
Enter the Hello Interval value between the hello packets that the router sends on
an interface here. The range is from 1 to 65535 seconds. Select the Default
option to use the default value, which is 10 seconds.
Dead Interval
Enter the Dead Interval value, during which no packets are received and after
which a neighbor is regarded as offline, here. The range is from 1 to 65535
seconds. Select the Default option to use the default value, which is 40 seconds.
Transmit Delay
Enter the transmit delay value here that the router uses to wait before it transmits
a packet. The range is from 1 to 65535 seconds. Select the Default option to use
the default value, which is 1 second.
Retransmit Interval
Enter the retransmit interval value here that the router uses to wait before it
retransmits a packet. The range is from 1 to 65535 seconds. Select the Default
option to use the default value, which is 5 seconds.
Click the Apply button to accept the changes made.
The fields that can be configured in OSPF Virtual Link Table are described below:
Parameter Description
Process ID
Enter the ID for an IPv6 OSPF routing process here. The range is from 1 to
65535.
Click the Find button to locate a specific entry based on the information entered.
Click the Process ID link (1) to access and configure the specified OSPFv3 process.
Click the Delete button to delete the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.