DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
331
Figure 6-165 IPv6 Static Multicast Route Settings Window
The fields that can be configured are described below:
Parameter Description
IPv6 Address/Prefix Length
Enter the IPv6 network address and prefix length of the multicast source here. A
decimal value that indicates how many of the high-order contiguous bits of the
address comprise the prefix (the network portion of the address). A slash mark
must precede the decimal value.
Interface VLAN
Enter the VLAN ID that will be used here. The range is from 1 to 4094.
RPF Neighbor Address
Enter the IPv6 address of the next hop that can be used to reach the specified
network here. Select the NULL option to specify that the RPF check result will
always fail.
Click the Apply button to accept the changes made.
Click the Clear All button to clear the information displayed.
Click the Delete button to remove the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
IPv6 Multicast Routing Table
This window is used to display the contents of the IPv6 dynamic multicast routing table.
To view the following window, click L3 Features > IP Multicast Routing Protocol > IPv6MC > IPv6 Multicast
Routing Table, as shown below:
Figure 6-166 IPv6 Multicast Routing Table Window
The fields that can be configured are described below:
Parameter Description
Group IPv6 Address
Enter the multicast group IPv6 address here.
Source IPv6 Address
Enter the multicast source IPv6 address here. Selecting the Summary option
specifies to display a one-line, abbreviated summary of each entry in the IPv6
To Next Page
Loading...
