DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
410
Click the Set Action button to configure the set action settings for the specified entry.
Click the Policer button to configure the policer settings for the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Set Action button, the following page will appear.
Figure 7-17 Policy Map (Set Action) Window
The fields that can be configured are described below:
Parameter Description
None
Select this option to specify that no action will be taken.
Specify
Select this option to specify that action will be taken based on the configurations
made.
New Precedence
Select the new precedence value for the packet here. The range is from 0 to 7.
Select the IPv4 only option to specify that IPv4 precedence will be marked only. If
not selected, then both IPv4 and IPv6 precedence will be marked. For IPv6
packets, the precedence is the most three significant bits of the traffic class of the
IPv6 header. Setting the precedence will not affect the CoS queue selection.
New DSCP
Select the new DSCP value for the packet here. The range is from 0 to 63. Select
the IPv4 only option to specify that the IPv4 DSCP will be marked only. If not
selected, then both the IPv4 and IPv6 DSCP will be marked. Setting the DSCP
will not affect the CoS queue selection.
New CoS
Select the new CoS value to the packet here. The range is from 0 to 7. Setting the
CoS will not affect the CoS queue selection.
New Cos Queue
Select the new CoS queue value to the packets here. This will overwrite the
original CoS queue selection. Setting the CoS queue will not take effect if the
policy map is applied for the egress flow on the interface.
Click the Back button to return to the previous window.
Click the Apply button to accept the changes made.
After clicking the Policer button, the following page will appear.
To Next Page
Loading...
