DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
418
Figure 7-26 WRED Profile Window
The fields that can be configured are described below:
Parameter Description
Profile
Enter the WRED profile ID here. The range is from 1 to 128.
Packet Type
Select the packet type here. Options to choose from are TCP and Non-TCP.
• TCP - Specifies the WRED drop parameters for the TCP packets to be set.
• Non-TCP - Specifies the WRED drop parameters for non-TCP packets to be
set.
Packet Colour
Select the packet color here. Options to choose from are Green, Yellow, and
Red.
• Green - Specifies the WRED drop parameters for green packets to be set.
• Yellow - Specifies the WRED drop parameters for yellow packets to be set.
• Red - Specifies the WRED drop parameters for red packets to be set.
Min Threshold
Enter the minimum threshold value here that will be used to start WRED dropping.
The range is from 0 to 100.
Max Threshold
Enter the maximum threshold value here over which WRED will drop all packets
destined for this queue. The range is from 0 to 100.
Max Drop Rate
Enter the maximum drop-rate value here. The range is from 0 to 14. This feature
specifies the drop probability when the average queue size reaches the maximum
threshold. When this value is zero, then the packet will not be dropped or
remarked for ECN.
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Reset Configuration button to reset the configuration on the specified entry.
To Next Page
Loading...
