D-Link DGS-3630 SERIES - Page 486

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
474
Figure 9-29 RADIUS Global Settings Window
The fields that can be configured in RADIUS Global Settings are described below:
Parameter Description
DeadTime
Enter the dead time value here. This value must be between 1 and 1440 minutes.
By default, this value is 0 minutes. When this option is 0, the unresponsive server
will not be marked as dead. This setting can be used to improve the
authentication processing time by setting the dead time to skip the unresponsive
server host entries.
When the system performs authentication with the authentication server, it
attempts one server at a time. If the attempted server does not respond, the
system will attempt the next server. When the system finds a server does not
respond, it will mark the server as down, start a dead time timer, and skip them in
authentication of the following requests until expiration of the dead time.
Click the Apply button to accept the changes made.
The fields that can be configured in RADIUS Global IPv4 Source Interface are described below:
Parameter Description
IPv4 RADIUS Source
Interface Name
Enter the name of the IPv4 RADIUS source interface here.
Click the Apply button to accept the changes made.
The fields that can be configured in RADIUS Global IPv6 Source Interface are described below:
Parameter Description
IPv6 RADIUS Source
Interface Name
Enter the name of the IPv6 RADIUS source interface here.
Click the Apply button to accept the changes made.
The fields that can be configured in RADIUS Server Attribute Settings are described below:
Parameter Description
RADIUS Server Attribute
NAS-IP-Address
Enter the RADIUS server’s attribute NAS-IP-Address here.
Click the Apply button to accept the changes made.