D-Link DGS-3630 SERIES - Page 590

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
578
Parameter Description
specified delay time after the primary PW comes back. The range is from 0 to 180
seconds.
Selecting the Never option specifies not to switch back to the primary PW even if
it comes back. This is the default option.
Click the Apply button to accept the changes made.
The fields that can be configured for Dot1q Tunneling Ethertype Settings are described below:
Parameter Description
Dot1q Tunneling Ethertype
Enter the outer TPID for the service VLAN tag here. This value is in the
hexadecimal from 0x1 to 0xFFFF. Select the None option to disable this feature.
Click the Apply button to accept the changes made.
The fields that can be configured for VLAN Mode Settings are described below:
Parameter Description
VLAN Mode
Select the VLAN mode of the PW here. Options to choose from are:
• No Change - Specifies not to change the VLAN tag on the ingress packet.
This can only be applied on Ethernet VLAN-based ACs.
• Add VLAN - Specifies to add the configured VLAN tag to the ingress packet.
The default action for port-based ACs is to add the VLAN ID 0. This can be
applied on both Ethernet-based and Ethernet VLAN-based ACs.
• Change VLAN - Specifies to change the VLAN tag of the ingress packet to
the configured VLAN ID. This can only be applied on Ethernet VLAN-based
ACs.
Select the None option to use the default setting.
Click the Apply button to accept the changes made.
The fields that can be configured for Egress VLAN Mode Settings are described below:
Parameter Description
Egress VLAN Mode
Select the egress VLAN mode of the PW here. Options to choose from are:
• Strip - Specifies that the outer-tag of the packet will be stripped before
egress on the AC.
• Change VLAN - Specifies that the outer-tag of the packet will be changed to
the VLAN ID of the AC before egress on the AC. This can only be applied on
Ethernet VLAN-based ACs.
Select the None option to use the default setting.
Click the Apply button to accept the changes made.
After clicking the Show Detail button, the following page will appear.