DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
623
Figure 15-24 Trace Route Window
The fields that can be configured in IPv4 Trace Route are described below:
Parameter Description
VRF Name
Enter the name of the VRF instance here. This name can be up to 12 characters
long.
IPv4 Address
Select and enter the IPv4 address of the destination here.
Domain Name
Select and enter the domain name of the destination here.
Initial TTL
Enter the initial Time-To-Live (TTL) value here. The range is from 1 to 255.
Max TTL
Enter the Time-To-Live (TTL) value of the trace route request here. This is the
maximum number of routers that a trace route packet can pass. The trace route
option will cross while seeking the network path between two devices. The range
for the TTL is 1 to 255 hops.
Port
Enter the port number here. The value range is from 1 to 65535.
Timeout
Enter the timeout period while waiting for a response from the remote device
here. A value of 1 to 65535 seconds can be specified. The default is 5 seconds.
Length
Enter the length value here. This specifies the number of bytes of the outgoing
datagram. The range is from 1 to 1420 bytes.
ToS
Enter the ToS value here. This specifies the ToS to be set in the IP header of the
outgoing datagram. The range is from 0 to 255.
Frequency
Enter the frequency time for the trace route here. The range is from 0 to 86400.
Source IPv4 Address
Enter the source IPv4 address here. The specified IPv4 address must one of the
IPv4 addresses configured for the Switch.
Probe Number
Enter the probe time number here. The range is from 1 to 1000. If unspecified, the
To Next Page
Loading...
