6 Input/Output
6.2 Input
This is the same as the control in the Preset dropdown, and also the same as
Input/Output button in the Restore Defaults menu under System.
All the variables set under the Input/Output front panel key are reset by
Input/Output Preset, including Amplitude Corrections and Data (described in the
Corrections section), with the exception of RF Source settings, which are
unaffected.
By using Input/Output Preset and Restore Mode Defaults, a full preset of the current
mode will be performed, with the caveat that since Input/Output Preset is a global
function it will affect all Modes.
When Input/Output Preset is selected, a message appears saying:
“This will reset all of the Input/Output variables to their default state, including
which input is selected, all Amplitude Correction settings and data, all External
Mixing settings, all Frequency Reference settings and all Output settings.
It will not affect Alignment data or settings.
It will not affect RF Source settings.
This action cannot be undone. Do you want to proceed?”
Use the OK or Cancel buttons to affirm or cancel the operation.
Example
:SYST:DEF INP
presets all Input/Output variables to their factory default values
Vector Modulation Analyzer Mode User's &Programmer's Reference 2188
To Next Page
Loading...
Need help?
General
